Warranty

10
OW1
4
USE PART 10 &
THIGHTEN INTO
STUD IN WALL
1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL .
2. LIGHTLY MARK YOUR WALL USING A PENCIL WHERE UPPER MOST STRUT INTERSECTS WALL STUD.
3. REMOVE UNIT FROM WALL AND PREDRILL YOUR 8 MARKED SPOTS USING A
3
16
" DRILL BIT.
4. REPLACE UNIT TO DESIRED LOCATION AGAINST WALL AND WRAP PART 8 AROUND UPPER MOST
LADDER STRUT. FASTEN THE WRAPPED STRAP INTO WALL USING THE 1/4" ALLEN WRENCH (PART 10)
AND SCREWS (PART 9) PROVIDED. DO NOT OVER TORQUE!
IMPORTANT: TO INSURE PROPER AND SAFE INSTALLATION OF YOUR SHELF; YOU MUST:
IMPORTANT: FAILURE TO PROPERLY SECURE UNIT WITH PROVIDED
STRAP MAY RESULT IN INJURY
8
10
9