Instructions / Assembly

7
SDS1
3
TIGHTEN
SET SCREW
3
3
6
FROM STEP 2
1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL LINING AT LEAST ONE SIDE UP WITH A STUD.
2. LIGHTLY MARK YOUR WALL USING A PENCIL IN EACH MOUNTING HOLE ON THE FLANGES.
3. REMOVE UNIT FROM WALL AND PREDRILL YOUR MARKED SPOTS USING A
3
16
" DRILL BIT.
IF NOT GOING DIRECTLY INTO STUD, USE ANCHOR (ITEM 7). DRILL
5
16
" HOLE AND HAMMER
ANCHOR INTO PLACE.
4. PLACE UNIT BACK ON WALL AND INSERT SCREWS (ITEM 4) INTO FLANGES & TIGHTEN USING ITEM 5.
DO NOT OVER TORQUE.
IMPORTANT: FAILURE TO PROPERLY SECURE UNIT TO WALL
AS SHOWN MAY RESULT IN INJURY.