Assembly Instructions ASSEMBLY RATING Tools Required For Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench =) assembling a specific product {with 1 being (included) easy and 5 being difficult). For some . ) products, two persons are recommended.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES When lock or spring washer is used in an assembly, please make sure the lick or spring washer is placed between the larger flat washer and the head of the screw or bolt, Some furniture comes with height adjustment knobs underneath each leg.
Before you begin, please read Page 2 i, of "Assembly and Ca And remember, do not tighten until each step is completed or instructed. re Advice".
/| Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until ’ %@ each step is completed or instructed. Hardware List r #A x PCs #H x PCs &= | screw M5 x comm Y Hex Nut PCs O # x 1pc Bolt 1/4" Screw M4 x 37MM N PCs #J x PCs Bolt 1/4" X 3" % Keyhole Slot 1pc % #K x 1pe Allen Wrench M4 Explosive nut PCs *Q #L x 1pc Screw M4 x 25MM Tipping Restraint 1pc #M x PCs % Socket = Flat Washer poss Screw M3 x 10MM \commemoration? Page 4 of 10
’ #G % PCs] | 1 Align the up tube frame (#3) to the holes along the #Ix1pc top of the left and right support frames Then apply a keyhole soot {8} into 2 hoist insert those into the upper holes and Insert a bolt (#C) into the dower holes, Secure using the Allen wrench (0}, 2. Align the riddle tube frame (#5) to the holes along the center of the left and right support frames Then insert a obit (#C} into each hole, Secure using the Allen ranch.
Align the desktop support bars {#7) to the holes along the center of the left and right support frames Then insert a Holt (#B) into each end. Secure using the Allen wrench #B x PCs / Align the socket {#F) ta the hales along e the middle tube frame then insert #E x Bps 2 screws (#G) and secure using a Phillips #F x 1pc screwdriver. On the other side apply a #G x PCs . hex nut ) onto each screw and tighten. #H x PCs #M x PCs 1.
# x1pc Drill @ hole sightly smaller than the explosive nat then push the nut {#K} into the holey, After that align a keyhole soot to the nut and insert a screw Secure using a Phillips screwdriver.
Before you begin, please read Page 2 of "Assembly and Care Advice". And remember, do not tighten until each step is completed or instructed.
Place the legs (#2) and 3} face down and align the center hole, then insert a bolt {#4) and secure using the Allen wrench #B x PCs #D x PCs Place the seat {#1) face down, then place & rubber mat (D) oat each hole. Place the legs face down onto those rubber mats {#D} and insert 2 bolt {#8} into aah hole.
