Instructions / Assembly

I. Place the backrest with legs (#1) on a protected surface.
Align the seat (#2) with the pre-drilled holes of the backrest
with legs (#1).
II. Prepare a bolt assembly by inserting FIRST the lock washer
(#B) onto the bolt (#C) and then the flat washer (#A) onto the
SAME bolt (#C), in that order.
III. Insert the bolt assembly through one of the
pre-drilled holes in the center of the seat (#2)
and secure the bolt using the Allen
wrench (#F) to lock it with the backrest with legs (#1).
Repeat the process with second bolt.
I. Prepare 4 bolt assemblies by inserting FIRST the lock
washer (#B) onto the bolt (#E) and then the flat washer
(#A) onto the SAME bolt (#E), in that order.
II. Insert the bolt assemblies through the pre-drilled holes
in the corners of the seat (#2) and secure those bolts using
the Allen wrench (#F) to lock them onto the backrest with
legs (#1).
Note: Right and left are determined
by facing the FRONT of the chair
in its upright position.