Assembly Instructions ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating isa 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being iii : EE easy and 5 being difficult). For mast Phillips Screwdriver et dead products; two persons are recommended.
90-DAY LIMITED REPLACEMENT PARTS WARRANTY This item comes with a 90-day limited replacement parts warranty to the original purchaser of new products against defects in materials and workmanship for a period of ninety (90) days from the date of receipt. This warranty is not nontransferable.
PARE & CARE ADVICE FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES Ei lis Highly recommended that the assembly should be doe near the area of its intended location. Make sure you have though space lo move around diffing the assembly. ALWAYS have at least wo people to help with transposing and assembling the product avoid any potential injury undercarriage.
PER-ASSEMBLY INTRODUCTION Unless you are particularly adept at assembling furniture, we understand building ready-to-assemble furniture can bea frustrating experience foursome. To help avoid confusion and to make the ‘assembly process quicker and smoother, we have provided some helpful tips. Before you begin the assembly, please read the following: 1. [Due tithe weight on most of the ready-to-assemble furniture, iris highly recommended that the assembly should be done near the area of iis intended location.
CAM LOCK FASTENER ASSEMBLY INSTRUCTIONS Note: Every cam lock bolt must have a cam lock connector in order to fasten the parts together. 1 Align the cam connector with its Secure the threaded I side opening (or arrow) end of the cam bolt pointing to the small by using a drilled hole. screwdriver. or Turn right (clockwise) to tighten. Two parts should fit snugly (3) against each other. Insert the cam lock bolt into the per-drilled hole above the cam connector.
ASSEMBLY INST SONS Identifying Drawer's Rails Runners, Glides, Slides or Guides) An assembly of ONE drawer requires a set of 4 different rails: right panel rail, left panel rail, right drawer rail and left drawer rail. To identify which rail belongs to which part, please read completely first before assembling. To Determine Right/Left Panel Rail: Place the panel rail flat on its back with the roller position on the left hand side.
ASSEMBLY INSTRUCTIONS STEP: 2 Hardware D x 4 pcs Hardware 8 x 8 pes (6x 30) Hardware (8) x 6 pcs STEP: 3 Hardware ® x 4 pcs Hardware 14 x 4 pes drawer rails Hardware §5 x 8 pcs Left Drawer Rail 7 hole Right Drawer Rail Front View ® _ Side View em front Page 8 of 12
ASSEMBLY INSTRUCTIONS STEP : 10 Hardware 2)x 4 pcs Dowel hole] i ® STEP : 11 Hardware {8 x 1 sets supplied with wall straps. We highly recommend securing the item to the wall using the supplied hardware and straps to prevent tip-over resulting in damages and/or injuries. Make sure the unit is rested on a flat surface and does not feel loose or wobbly.
