2. Insert the barrel nuts (#C), use a screwdriver to align the hole for the bolt. Back Front 3. Insert the bolt (#A) into the predrilled holes along the side and into the barrel nut (#C). Secure using the Allen wrench (#K). Make sure to hold the barrel nut with a screwdriver while securing the bolt. 1. Align the ends of the lower front side rail (#5) and the lower back side rail (#6) to the pre-drilled holes along the sides of the lower end guardrail (#1,2). 2.
#18 1. Align a guard rail (#20) to the pre-drilled holes along the ends of the front guard rails (#18) and upper front side rail (#16). Then insert 4 bolts (#E) and secure using the Allen wrench. #16 2. Align a guard rail (#19) to the predrilled holes along the center of the rails. Insert 3 screws (#F) into each guard rail (#19) and secure. 2. With the help of another person, carefully place the top bunk onto those metal dowels (#J). 1.
Align the top and bottom of the ladder (#7) to the pre-drilled holes along the front rails. Insert a bolt (#D) into each end from within the rails and secure using the Allen wrench (#K). Apply the twin slat kit (#9) onto the top bunk. Insert a screw (#F) into each end and secure using a screwdriver. Apply the full slat kit (#8) onto the top bunk. Insert a screw (#F) into each end and secure using a screwdriver.
2. Insert a wood dowel (#H) into the pre-drilled holes along the corners of the front panel (#10). 1. Place the front panel (#10) face down. 3. Place the right side (#12) and left side (#11) onto the other end of those wood dowels (#H). Note: Right and left is determined by facing the front of the front panel (#10) in its upright position. Insert 2 screws (#G) into the holes along the sides of (#11/12). Secure using a Phillips screwdriver.
Align the bottom panel (#14) to the ridges along the sides and carefully slide in. Place the back panel (#13) and insert 2 screws (#G) into each end. Secure using a Phillips screwdriver.
Align the center support (#15) to the pre-drilled holes along the center of the front and back panel (#10/13). Insert a screw (#G) into each end and secure using a screwdriver. From top Diagonal Repeat process for second drawer. Make sure all screws and bolts are firmly secured. Roll drawers under bed.
