User Guide
Table Of Contents
- 3 3RT1 contactors/ 3RH1 control relays
- 3.1 Specifications/regulations/approvals
- 3.2 Device description
- 3.3 Application and areas of use
- 3.3.1 3RT10 contactors with 3 main contacts for switching motors
- 3.3.2 3RT14 contactors with 3 main contacts for switching resistive loads (AC-1)
- 3.3.3 3RT12 Vacuum contactors
- 3.3.4 3RT13 and 3RT15 contactors with 4 main contacts
- 3.3.5 3RT16 capacitor contactors
- 3.3.6 Contactors with an extended operating range
- 3.3.7 3RH1 control relays
- 3.3.8 3RT10 contactor relays for switching motors (interface) and 3RH11 control relays for switching auxiliary circuits
- 3.3.9 3RA13 Contactor combinations for reversing
- 3.3.10 3RT14 Wye-delta combinations
3RT1 contactors/3RH1 control relays
SIRIUS System Manual
GWA 4NEB 430 0999-02 DS 01
3-53
The following graphics show you how to install the front mount mechanical interlock with frame sizes
S2 and S3:
Drawing: Frame sizes S2/S3 Step Procedure
1/2 Place the contactors even to one
another (1) and plug-in both of the con-
nection clips to the backside (2).
3 Push the sliding switch on the upper
portion of the mechanical interlock to
RESET, in order to be sure of the condi-
tional state of the module (3).
First attach the mechanical interlock in
the contact opening of the left contac-
tor (4), then with a swinging motion
attach the mechanical interlock in con-
tact opening of the right contactor (5)
and pull the interlock downward until it
sits securely in place (6).
7 In the proper operational condition, the
upper sliding switch on the front side
of the mechanical interlock is to the left
and the lower sliding switch is to the
right.
Table 3-18: Installation of the front mounted mechanical interlock (frame size S2/S3)
1
2
3RA1932-2C
3
4
5
6
RESET
7