User Manual

4. Configure the Piko BLX for SBus using the Cleanflight configurator
- In the PORTS tab, select UART3 and activate Serial RX.
- Save by clicking on the Save and Reboot button.
- In the CONFIGURATION tab, in the Receiver Mode section, select RX_SERIAL.
- In the same tab, in the Serial Receiver Provider section, select SBUS.
- Save by clicking on the Save and Reboot button.
- Go to CLI and type the following commands:
set sbus_inversion = OFF
save
- The FC will reboot, applying the change.
- Go to the RECEIVER tab and make sure the receiver acts like it should.
5. Telemetry configuration
- In the PORTS tab, select UART2 and select FrSky in Telemetry. Leave the baud rate to AUTO.
- Go to CLI, and type the following commands:
set telemetry_inversion = OFF
save
The FC will reboot, applying the change.
- Make sure you’re getting the telemetry values in our Taranis correctly.
6. Now continue with the setup of your model as normal.
Appendix 2 – Quick start with Spektrum Satellite
a. Start the Cleanflight configurator on your computer.
b. Plug your Spektrum Satellite into the Piko BLX.
c. Plug the Piko BLX into the computer, and connect to Cleanflight.
d. Click on the ports tab, and select UART3 as ‘Serial Rx’ as shown. Be sure to click on ‘save and
reboot’.