Safer Choice Standard

Report No. 130815040GZU-001
IMPERIAL INDUSTRIAL SUPPLY
Page 17 of 33
Issued: 23-Dec-2013
Revised: None
Photo #
Item
no.
1
Name
Manufacturer/
trademark
2
Type / model
2
Technical data and securement
means
Mark(s) of
conformity
3
4.0 Critical Components
15 27 Heater
NANFANG
MACHINE
FACTORY
Various
Rated 120Vac, 60Hz, 750W.
Welded with the inner kettle.
Heating Element material
OCr25AL5, MgO was mpregnated
between the heating element and
sheath as insulator. Aluminium
Sheath was welded into the
heating plate. Fe-ni cold pin was
measured Ø2.0 mm. Kept spacing
min. 3.1 mm from the cold pin to
the sheath by Ceramic End. Fe-ni
Connecting Pin was welded on
each cold pin, 0.8 mm thick by 7
mm x 13 mm. Provided an
opening for electric connection.
Refer to the illustration No. 4.
NR
15 28 Thermostat
LINTON
ELECTRICAL
LTD
IT-128
Rated 125 V, 60 Hz, 12A. Ts-
p=210℃. 100K cycles. Tightly
secured to the inner container by a
screw.
cURus
15 29
Thermal Fuse
Assembly
Various Various It consists of the following parts: NR
15 29a
Thermal Fuse
(Not Shown)
NEC SCHOTT
COMPONENTS
CORP
SF240E
Rated 250Vac, 10A. Tf=240℃.
Enclosed by recognized Silicone
rubber tubing with outer braid of
silicone-varnished fiberglass,
clamped by a metal sheet, and
then secured to the kettle by
screw and two ceramic washers,
the metal sheet is Galvanized
steel, measured 0.35 mm thick, 14
mm wide.
cURus
15 29b
Silicone rubber
tubing with outer
braid of silicone-
varnished
fiberglass
Various Various
Rated 300 V, at least 220 ℃, VW-
1. Ø7 mm, entirely enclosed the
thermal fuse.
cURus
15 29c Ceramic Washer Various Ceramic
Two provided, Ф12 mm by 6.8 mm
high
NR
15 29d Mica Washer Various Mica
0.2 mm thick, provided between
Ceramic Washer and Bottom of
inner kettle.
NR
15 30
Silicone rubber
coated fiberglass
sleeving
Various Various
Rated 300 V, at least 220 ℃, VW-
1, entirely enclosed the internal
wire to heater, thermostat.
cURus
16 31
Cord Clamp in
Terminal Box
HYOSUNG CORP J801R
PP material, rated HB, 120℃.
Overall measured 24 mm x 7 mm,
and min. 2.0 mm thick. Secured
the Power cord of Kettle to
terminal box by 2 screws served
as strain relief device.
cURus
15 32 O-Ring
MOMENTIVE
PERFORMANCE
MATERIALS
SE-6035
Silicone Molding Resin material,
rated 200℃. Provided between
outer kettle and inner kettle
serviced as seal material.
URus
ED 16.3.15 (1-Jan-13) Mandatory