Safer Choice Standard

Report No. 130815040GZU-001
IMPERIAL INDUSTRIAL SUPPLY
Page 15 of 33
Issued: 23-Dec-2013
Revised: None
Photo #
Item
no.
1
Name
Manufacturer/
trademark
2
Type / model
2
Technical data and securement
means
Mark(s) of
conformity
3
4.0 Critical Components
HEAVY POWER
CO LTD
PA8
Rated 300 V, 20 A, 105℃, suitable
for 12-22 AWG Cu-wire. Secured
to the Terminal Box by screw.
cURus
HEAVY POWER
CO LTD
PA10
Rated 300 V, 30 A, 105℃, suitable
for 10-22 AWG Cu-wire. Others
same as above.
cURus
8 11
Flat Warming
Plate Assembly
NANFANG
MACHINE
FACTORY
Various
Rated 120V, 60Hz, and 50W. The
assembly clamped by two metal
sheets, and then secured to
Bottom cover by 2 screws and
nuts. It consists of following parts.
Refer to Illustration 6 for details.
NR
8 11a Housing Various Various
Aluminum, min.0.5 mm thick.
Overall measured 40 mm x 190
mm x 3.5 mm.
NR
8 11b Mica Sheet Various Mica
0.4 mm thick, six provided,
serviced as bracket of heating
element and electrical insulation.
cURus
8 11c Heating Element Various Various
Cr5AL5 alloy material, measured
288 Ohm. Wrapped on the Mica
sheet. Maintained min. 3.1 mm
spacing to Housing.
NR
Various 10362
Rated 250℃, 600V, Min. 22AWG.
cURus
Various 3122
Rated 200℃, 300V, Min. 20AWG.
cURus
10 15
Close-end
Connector
Various Various
Rated 300V, min.80℃.
cURus
10 16 Cable Tie Various PA material
Rated at least 80℃, provided to
band electric wiring to avoid
mechanical injury.
cURus
10 17 Lamp Assembly
NANFANG
MACHINE
FACTORY
Various
All accessible edges were smooth
and well rounded. It consisted of
the following parts:
NR
10 17a Lamp Various Various
Tungsten-filament lamp. Rated
120 Vac, 60 W.
NR
10 17b Lamp Holder
RUI CHENG
ELECTRICAL
PART FACTORY
RS-1905
Lampholders incandescent
medium base. Rated 250Vac, 660
W. The screwshells connected to
the grounded conductor.
cULus
10 17c
Securing Plate (for
models FT862CR
& FT824PP only)
Various Various
Galvanized steel, 0.4 mm thick,
overall 112 mm x 55 mm x 36
mm. Clamped the lamp holder
and then secured to lower cover
by 2 screws.
NR
10 17d
Securing Plate (for
model FT825CR)
Various Various
Enameled Steel, min. 0.7 mm
thick. Two parts construction,
measured overall dimensions of Ф
100 mm x78 mm. Fixed together
and secured on lower cover for
upper enclosure by screwing and
riveting.
NR
7,
16
8
Terminal Block in
Terminal Box
10
Lead Wire11d
ED 16.3.15 (1-Jan-13) Mandatory