USDA Certification

Report No. 130815042GZU-001
IMPERIAL INDUSTRIAL SUPPLY
Page 10 of 26
Issued: 23-Dec-2013
Revised: None
Photo #
Item
no.
1
Name
Manufacturer/
trademark
2
Type / model
2
Technical data and securement
means
Mark(s) of
conformity
3
4.0 Critical Components
6 26 Heater
Foshan Eden
Electrical CO.,Ltd
Various
Rated 120Vac, 60Hz, 270W.
Welded with the inner container.
Heating element material
OCr25AL5, insulator was MgO, Ø
2.0mm Fe-ni Cold pin, Ceramic
End for Kept spacing min. 3.1mm
from the cold pin to the sheath.
Connecting Tab were welded on
each cold pin, 0.8mm thick by
7mm x 13mm. Provided an
opening for electric connection.
NR
6 27 Thermostat
LINTON
ELECTRICAL
LTD
IT-128
Rated 125 V, 60 Hz, 12A. Ts-
p=210℃. 100K cycles. Tightly
secured to the inner container by a
screw.
cURus
6 28
Thermal Fuse
Assembly
Various Various It consists of the following parts: NR
6 28a
Thermal Fuse
(Not Shown)
NEC SCHOTT
COMPONENTS
CORP
SF240E
Rated 250Vac, 10A. Tf=240℃.
Enclosed by recognized Silicone
rubber tubing with outer braid of
silicone-varnished fiberglass,
clamped by a metal sheet, and
then secured to the container by
screw, one ceramic washer and
one mica washer, the metal sheet
is Galvanized steel, measured
0.35mm thick, 14mm wide.
cURus
6 28b
Silicone rubber
tubing with outer
braid of silicone-
varnished
fiberglass
Various Various
Rated 300 V, at least 200 ℃, VW-
1. Ø7mm, entirely enclosed the
thermal fuse.
cURus
6 28c Ceramic Washer Various Ceramic
One provided, Ф12mm by 6.8mm
high
NR
6 28d Mica Washer Various Mica
0.2mm thick, provided between
Ceramic Washer and Bottom of
inner kettle.
NR
6 29
Fiberglass
sleeving
Various Various
Ф3.5mm, 0.26mm thick. Entirely
enclosed the all internal wiring in
containerexcept for grounding.
NR
7 30 X2 Capacitor Various Various
Electromagnetic Interference
filters, rated 250V, 0.56uF, 85°C
minimum. Fitted to Terminal
Block.
cURus
3) Indicates specific marks to be verified, which assures the agreed level of surveillance for the component. "NR" - indicates Unlisted and
only visual examination is necessary. "See 5.0" indicates Unlisted components or assemblies to be evaluated periodically refer to section
5.0 for details.
NOTES:
1) Not all item numbers are indicated (called out) in the photos, as their location is obvious.
2) “Various“ means any type, from any manufacturer that complies with the "Technical data and securement means" and meets the "Mark(s)
of conformity" can be used.
ED 16.3.15 (1-Jan-13) Mandatory