Instructions / Assembly

threads. If a thread protrudes from the T-Nut, undo the entire bolt, and add washers to eliminate the

risk of a protrusion hazard.

Proper Hardware Assembly

As a general rule of thumb, your pilot hole should be slightly smaller than the diameter of your screw.

This will remove as much material as possible, which will reduce the likelihood of splitting, but will

still leave enough material for the screw's threads to grip into. Once the pilot hole is drilled, you can

install the screw. Drive the screw in, being careful to angle it to follow the path of the hole. Repeat

this process for each screw used. For large screw please first slip a flat washer over the screw.

For bolts, gently tap the relevant T-Nut into the hole using a hammer on the opposing site. Following

the placement of the T-Nut, first slip a lock washer and a flat

washer over the bolt. During the initial

assembly you are not required to fully tighten the bolt to allow room for adjustment. Once your

playhouse has been fully assembled, please ensure all bolts are fasten properly and that you have fully

tightened all bolts used and no protrusion hazard has been cr

eated. Wafer head bolts with blue lock

tight or a bolt with a Ny-Lok nut do NOT require a lock washer.