Operation Manual

VID:
•
Please set the VID as specified by your Service Provider.
User Priority:
•
defines a user priority using eight different priority levels (2^3). IEEE 802.1P specifies the use of the three user prio
-
rity bits. Normally, this value is defined by your Service Provider.
CFI:
•
The Canonical Format Indicator is always set to zero by Ethernet Switches. CFI is used to ensure the compatibility of
Ethernet and Token Ring networks. When an Ethernet interface receives a frame with a CFI value of “One”, that fra
-
me should not be forwarded to an unmarked interface without any processing.
•
If you activate the VLAN Packets option and enter values for VID, User Priority and CFI, all incoming packets that
bear the IP address of the phone and the same VID will be accepted. Packets that have the phone IP address, but a dif
-
ferent VID are rejected by the phone. Packets with a different IP address are routed to the PC via the LAN interface.
DMZ-Setting
•
DMZ: When set to »On«, all packets (except for SIP-specific ones) will be forwarded to the IP address that has been
entered under »DMZ Host IP«.
•
DMZ Host IP:Input the IP address that is to be used for the DMZ.
Configuring a virtual server (Virtual Server Settings)
You can configure the virtual server on this page.
•
Virtual Server Page: You can configure up to 24 »Virtual Servers«.
•
Enable: Activating the specific server.
•
Protocol: Defining the TCP or UDP protocol.
•
In Port: Defining the internal port.
•
Ex Port: Defining the external port.
•
Server IP: Setup of Server IP Address.
•
Select: Selecting the configuration
•
Enable Selected: Activating the selected server.
•
Delete Selected: Delete the selected server.
•
Delete All: Delete all entries.
•
Reset: Resetting all entries.
•
Add Server: Adding a configuration.
Appointment reminder calls (Alarm setting)
45