Operation Manual
Telephone description
IP is the abbreviation for Internet Protocol. An IP phone is a telephone transporting voice by grouping data package of IP protocol.
An IP phone transports voicemessage over data communicationnetwork at extremely low pricebutof excellent sound quality just likeordi
-
nary fixed telephone lines do. With our »funkwerk IP 50« Internet phone, you’re going to save dramatically on internetional calls.
»funkwerk IP 50« Internet phone functions much like an ordinary telephone switching between inner and out line, it brings great conven
-
ience to the users. In the internal mode, calls between your »funkwerk IP 50« and any other »funkwerk IP 50« are free of charge . When IP 50
series IP net phone is in generalized out line mode, it can place calls to every ordinary telephones in the world at an extremely low price.
With its stability, sound quality, compatibility and rich functionalities, »funkwerk IP 50« leverages your wealth with high quality
communications!
Safety notes
•
Mind the storage and operation temperatures for the device listed in the technical specifications. Only connect the device when the permissible
ambient operating temperature has been reached.
•
Pleasenotethat condensation on orinthe unitmustbeprevented when movingfrom cold to warm surroundings. Only remove the unit from the
package when the permissible ambient operating temperature has been reached.
•
You should not make calls or connect or disconnect any lines during thunderstorms.
PUNKT 5 = Be sure to connect all cords and cables only to their designated ports.
PUNKT 5 = Be sure to route cords and cables so nobody can trip over them.
•
Avoid the following:
Direct sunlight
Sources of heat (for example radiators)
Electronic devices (for example stereo components, office equipment or microwave devices)
Ingress of moisture or liquids
Aggressive fluids or vapors
Dusty environment
PUNKT 5 = Do not use the unit in moist areas or where there is a risk of explosion.
PUNKT 5 = Do not expose any internal parts of the unit unless you are instructed to do so by the installation and operating manual.
PUNKT 5 = Do not touch any connector pins with sharp metallic items or damp objects.
PUNKT 5 = If the unit is not fixed to a surface, place it and its accessories on an anti-skid mat or equivalent.
PUNKT 5 = Clean the unit using only a slightly dampened piece of cloth.
•
Only use approved accessories.
•
Onlyterminalswith SELV and/or whichcomplywith ETS 300047 maybe connected tothe unit. Thisregulation is fulfilledwhenapproved termi
-
nal devices are used as intended.
Plug-in power supply
•
Use only approved power plug-in units.
•
Do not use power plug-in units with visible defects or damage (fissures, cracks, etc. )
Elektrostatic charges (protection against electrostatic charges)
•
Thetelephoneis supplied withenhanced ESD protection against theeffects of electrostatic discharge thatexceeds the protection level cited inthe
approval specification. Elevated ESD levels should nevertheless be avoided to the greatest possible extent. In some cases, electrostatic discharge
levels can far exceedthe approval limits or the resistance levels already implemented in your telephones. Eliminate the causes or conditions that
promote these elevated ESD levels, such as insufficient humidity or carpeting. The telephone manufacturer does not assume any liability for
damage caused under such circumstances.
Unpacking and placing the telephone
•
funkwerk IP50
•
Handset with handset connecting cord
•
Cat.5 Connection cable, approx. 2 m
•
Brief description of functions
•
CD-ROM with User Manual
Telephone description
3