Operation Manual

<>
O
The time between dialing can be set in steps of 3...9 seconds.
Select the desired value.
Confirm your entry using the »OK« button.
Auto dial:
3 (3-9 seconds)
Network
Remember that some settings may not be effective until the phone is restarted.
Your phone is equipped with two Ethernet ports: LAN and WAN. The WAN port is linked to the router or modem. The LAN port represents
a dedicated network and must be configured as such.
Here, you can configure the network ports for WAN and LAN.
Begin as follows:
a
M<>O
»Menu« button
4.Network
WAN Settings
<>
O
Select »1.WAN Setup«.
Confirm your entry using the »OK« button.
1.WAN Setup
2.LAN Setup
<>
O
Select »1.IP Type«.
Confirm your entry using the »OK« button.
1.IP Type
2.Fixed IP setti
<>
If the IP address is obtained automatically by a router or a
PABX system activate »2.DHCP-Client«.
If fixed IP addresses are to be assigned in the network activate
»1.Fixed IP clien«
If your phone is connected directly to a DSL or cable modem
activate »3. PPPoE client«
1.Fixed IP clien
2*DHCP client
3.PPPoE client
O
Confirm your entry using the »OK« button>«.
Configuring a fixed IP-address
Begin as follows:
a
M<>O<>O <> O
»Menu« but
-
ton
4.Network 1.WAN Setup 2.fixed IP setti
<>
O
Select 1.IP Adress«.
Confirm your entry using the »OK« button.
1.IP Adress
2.Subnet mask
t
O
Enter an IP-address from your network (in this example
192.168.1.45
Confirm your entry using the »OK« button.
IP adress:
192.168.001.045
Configuration using the telephone
25