Operation Manual

(max.20characters.Thenentertheseparatemacrocommands.

Amacro’s command stringis limited to 26 characters. Eachcom

mand or button simulation consists of two characters. You can

therefore only link a maximum of 13 commands together, or, for

example,join 7 commands/ key strokesimulationswith afurther

12 digits.

Commands and keys for macro programming

A macro consists of various commands, orecall flash button strokes, that are compiled into one command sequence

and stored under a defined direct dialing key. When this function key is pressed, the individual commands

contained in the macro are executed one after the other.

The following commands are available for macro programming:

»B« Initiatingacall(sameaslifting the handset)

»D« Endingacall(sameasreplacingthehandset)

»ELSE« Alternativecommand,if arequiredcondition(e.g.»IFLA«or»IFLB«)is notfulfilled.

»IFLA«

»IFLB«

ExecutethismacroonlywhentheLEDforthefirstlevelisoff(»IFLA«)orflashes(»IFLB«). Ifthiscondition

isnotfulfilledtheprocedureisdiscontinued,orresumedafterthecommand»ELSE«(whereavailable).

»K« Keypadsequence;allofthefollowingcharacters/digitsare transmittedasakeypadsequence.

»LA« DeactivateLED

»LB« TheLED flashes

»LE« ActivateLED

»LZ« ActivateLEDfortwoseconds

»n« Dummynumber.

Ifanumber is enteredprior to executionof a macro(orfor example,dialed fromthe telephone) thisnum-

berisusedinplaceofthedummynumberinthemacro.

»P« Pause(1second)inthecommandsequence(betweentwocharacters/commands)

»RE« Re-establishthe phone’sidlestate.

Ifthereisanactiveconnectionatthisphone,execution ofthismacroiscanceledatthis point.

»SE« Activatingthe speaker(normalvolume)

»SA« Activatingthe speaker(lowvolume)

»T« DTMF-Sequenz:allofthefollowingcharacters/digitsaretransferredasDTMFdialing.

»TS« Testingaconnection.

If there is currently no connection active, or an outgoing connection can not be set up (for B. subscriber

busy),executionof themacroiscanceledatthispoint.

If you wish to incorporate a telephone key into a macro, press the corresponding key during macro programming

(this is indicated, for example by » s5« in the display). All keys used for operating the telephone during macro

programming (e. g. save, change entry position, delete entry or cancel) cannot be incorporated into the macro by

simply actuating them, but need to be linked with the macro by means of the following commands.

»c« ActuationoftheC-button.

»esc« ActuationoftheESC- button.

»f« Actuationofthemenubutton.

»« Actuationoftheleft arrowbutton.

Programming numbers