Operation Manual

·
Synchronizing of telephone and PABX system.
Information:
Please note that logging in and synchronization may take several moments!
Information:
If there is no connection to the PABX system (no LAN link, or the telephone has not been logged in, »©-----/
/---‰ « will be shown in the display instead of the time.
Configuring the IP-S400 without DHCP
Simple logging in under DHCP is explained on Page . If you have different settings in your PABX system you can
enter that data here. You can call up the data and IP address here for a system telephone logged in under DHCP, or,
you can change these settings if DHCP is de-activated.
Begin as follows:
a
Mss
Configuration TCP/IP settings
s Press the appropriate softkey. Main TCP/IP and
Network settings
Sys-Server
DHCP Server
Gateway
Own IP-address
Netmask
s Sys Server:
If the elmeg PABX system gateway serves simultaneous-
ly as the system server you do not need to input any data
here. If this is not the case you must click the Softkey
»No« and then enter the system server IP address here.
Gateway IP address when connecting directly to the el-
meg PABX system.
Act gateway as Sys
server too (IP) ?
No
ok
s DHCP Server:
Here, you can select whether your system telephone is to
be assigned its IP address automatically from the system
(»On«), or whether you wish to configure this feature on
your own (»Off«).
Use automatic IP
address setting ?
Off
On
s Gateway:
If »DHCP« is not activated you must enter the network IP
address here in which your system telephone is located.
IP address of
gateway
INA>192.168.1.250!
s IP address:
If you have selected »Off« under »DHCP«, you must enter
the IP address for the telephone as given by the PABX
system or by the network in which the system telephone
is located.
Own IP address (IPS-
Phone)
INA>192.168.1.51
Configuration Setting up the IP-S400
68