Operation Manual

If you press the softkey again, a waiting call is signaled only once.
The check mark next to »repeat« is deleted.
Call wait. tone
Volume
repeat˜
s Pressthe»Volume«softkey.
<>
O
Use the arrow buttons to set the volume of the call waiting signal.
The bar in the display indicates the current status.
Confirm your entry with OK.
Call wait. tone {}
vol.
- ©©©−- +
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Acknowledgement signals
With your ISDN system telephone you can select whether the acknowledgement signals are always active, never
active or only active when an incorrect entry is made. The default setting has the acknowledgement signal always
active.
Begin as follows:
a
Mss
Acoustic Ack. tones
A check mark displayed next to the individual softkeys indicates the current status.
s Press the softkey for the desired function:
»No«: Acknowledgement tones always off
»ok«: Acknowledgement signal always active.
»Only error tn«: Acknowledgment signal active for erroneous
input.
Acknowledge signal
active?
No
ok
Only error tn
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Idle
Notice tone volume for »Station guarding«
Youhavevariousoptions of settingyourtelephone to»Stationguarding« (see page 37).Youcanset your telephoneto
signal incoming calls by a brief acoustic signal while »Station guarding« is active. The volume of that idle tone is
adjustable.
Begin as follows:
a
Mss
Acoustic Quiet
<>
O
Usethearrowbuttonstosetthevolume. Thebarinthedisplayin
-
dicates the current status.
Confirm your entry with OK.
Idle tone volume {}
- ©©©−- +
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
Handset
Permanent handset volume setting
Begin as follows:
a
Mss
Acoustic Handset
Configuring and setting up the system telephone Acoustic
50