Operation Manual

Setting the tariff factor and the currency
Begin as follows:
a
Msss
Configuration Charge
»Charge« Enterthe new charge factor and confirm your entry by clicking »OK«. Thecharge factor length isre
-
strictedto4characters. Toentera comma,usetheasteriskkey.
»Currency« Enterthe new currencyand confirm your entry by pressing OK. The currencyname is restricted to 6
characters. The assignmentsfor the keypad for enteringletters, digits andspecial characters are de
-
scribedonpage12.
»delete?« All charge data stored in the telephone are deleted. Recognition and saving of the procedure that is
usedfortransferof costinformation(seepage40)is thenre-activated.
Programming a charge limit for an extension number
You can set up a charge account for each number (MSN) that has been entered in the telephone. An amount in the
configured currency that is available for making calls will then be allocated to this account for the defined number
(MSN). Once this amount has been exhausted, only free-of-charge calls can be directed for this MSN extension
number. When you have programmed specific dial ranges for this telephone, calls with costs can be directed to the
unrestricted numbers.
If this limit is reached during an ongoing call, the call can be completed.
When the amount for the account is increased, or when the accrued charges are cleared calls with costs can again be
made.
Information:
Attention: Not all service providers transfer charge rate information. If you make calls using a service provider
which does not transmit charge information, the charge account is ineffectual.
Configuration of a charge account for a phone number (MSN) is described below using MSN1 as the example
Begin as follows:
a
Msss>s
Configura
-
tion
MSN MSN-1 ...
MSN-10
Charge
t
O
Enter the amount that is available for this number for making
calls.
Confirm your entry with OK.
Dial inhib. by charge
Limit/EUR>10`
¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬
If you enter the amount available for making calls as »0«, the charge account is not activated.
Enabling or inhibiting an extension number (MSN) for outgoing calls
Each number stored in the phone (»MSN-1«…»MSN-10«) can be enabled or inhibited separately for outbound calls.
If you have inhibited an MSN for outgoing calls, no outgoing calls can be initiated through this number (e. g. MSN
assignment via function key). Incoming calls can continue to be received by this number.
If you attempt to set up a call using a number that has been inhibited for dialing, the following message is shown in
the display »Inhibit. : msn«.
Enabling or inhibiting of a number for outgoing calls is protected by an MSN-specific PIN. You must enter this PIN
in advance during configuration of the number (MSN). After that, you can inhibit or enable dialing of external
numbers (outgoing calls) for this MSN.
Setting the tariff factor and the currency Monitoring costs
39