Operation Manual

Error while receiving an SMS

There may be various reasons for it not being possible to receive an SMS, or for only having voice output:

The feature SMS has not been applied for (and approved) at your network service provider and/or

the provider of the SMS Service Center.

The SMS has been transferred by outside service providers which did not transmit this message

as an SMS.

Permanent number suppression (inhibit) is activated for your ISDN connection.

Ten SMS messages have already been stored in your telephone, preventing anyfurther SMS mes

sages from being received.

Silent signalling

If you do not wish calls to be signaled with the programmed ringer melody and volume, you can active the »Silent

signalling« feature. Depending on the specific setting, all calls will be displayed optically or along with a brief

acoustic signal. To set the volume for the brief acoustic signal, proceed as described on page37 or »R« in the display

shows that the function »Station guarding« is activated.

»No« The function »Station guarding« is deactivated.

»ok« Calls are signaled optically only (»Q« shown in the display).

»Ringing signal off« Calls are signaled first by a brief acoustic signal and then only optically (»q«).

Only for msn-1 The functions described above are configured only for MSN-1. This assumes that several

MSNs have been configured in the system telephone.

Quiet No / Ringing signal 0ff/ ok

You have the option of logging the accrued communication costs for your telephone. Youmust apply for this feature

to your network service provider.

Ask your service provider on the possibilities of charge data transmission. Please note that transfer of all cost

information from the exchange office to your telephone may not always be possible for technical reasons. Any price

reductions and special rates or convenience features utilized may result in differences between the data stored in the

telephone and information listed in the phone bill.

Procedures for charge rate transmission

There are several standardized procedures for transmitting call charge rates. Usually the same procedure is

employed at one connection that is recognized and stored automatically for future use by the telephone.

In the event that the type of charge information transmission is not stored in the phone, »Wrong charge type« then

appears in the display.

In this case you should delete all charge information stored in the telephone (see also: viewing/deleting total costs).

Recognition and saving of the procedure that is used for transfer of cost information is then re-activated.

Information:

You can set the tariff factor and the currency while configuring your telephone with the PC.

Silent signalling Monitoring costs