Operation Manual

Call signaling
Call signaling is effected using the ringing tone that has been set for the dialed number (MSN) in each telephone.
If you are using the telephone at an internal ISDN connection of certain elmeg PABX systems, you can program
special ringing melodies for internal and external calls.
Function keys and LEDs
You can program the five function keys on two levels with different functions via the PC configuration program for
thetelephone. Eachkey is equipped withanLED that is usedtodisplay the activefunction. Eachcoloris assigned to a
particular level for the function key. (level 1 - red / level 2 - yellow).
Press the key two times to reach the second level for the function keys. This must be done at a short interval.
LED call signaling and answering machine
flashesred: Incomingcalls
lityellow: Answeringmachineswitchedon
flashesyellow: Newmessagesrecordedbytheansweringmachine
Acknowledegement signals
Entries or settings you make at your telephone are sometimes confirmed by acknowledgement signals.
Positive acknowledgement signal (1 long tone):
The positive acknowledgement signal indicates that your input has been accepted and stored by the telephone.
Negative acknowledgement signal (3 short beeps):
Youwillhearthenegativeacknowledgementsignalwhenyourinputhasnotbeenacceptedbythetelephone,orwhen
invalid input has been made.
Displays for programmed features
s When the telephone is in the idle state, additional information
about functions that have been configured are shown on »Info«
line of the display. In this example: »-t-S-R-«.
Press the softkey »Info« if you wish to get more information
about the configured functions.
29.05.06 07:21
Info -T-S-r-
Tel. drctry
Idle
VIP
Caller list
<> Ifyouhaveprogrammedseveral features, press thearrowbuttons
to view the various settings.
ªªªªªªªªªªªªªªªªªªªªª
Inhibit/Menu access:
Guard for modification
Displays Configured function
»D«
Active appointment reminder set.
»I«
Dialing control or Call filter active,
Access to telephone menus is protected.
»q«
Function »Silent signalling« (notice tone only) active.
»Q«
Function »Silent signalling« (all calls) active.
(All call signals are switched off)
»U«
Call forwarding active.
»i«
Informationen on programmed function keys
FOR EXAMPLE.: Message enabled / inhibited.
»I«
Informationen through Messages (MWI) For example. auf Ihrer t-Netbox
»%«
Answering machine, time control, notification or remote operation (option module) active.
Description and installation Telephone display and buttons
14