Operation Manual

Youcanalso use specifictelephone features with the Audio-Outoutput (see page 52). Connect the speakers
5
witha
3. 5 mm stereo jack to the telephone’s Audio-Out
3
output, as shown in figure 5.
IP-S400 Audio in / Audio out
Thetelephone is equipped with aninput
2
andan output
3
for audio signals. These ports are provided for headsets
6
. The jacks are linked to the corresponding ports for the headset jacks on the bottom of the telephones.
elmeg IP-S400 at the Ethernet-port
The IP-S400 system phone can be powered through the Ethernet port as defined in IEEE Std 802.3af-2003 (PoE),
with power being supplied via Ethernet from the hub or switch. At the port, »Alternative A« and »Alternative B«, as
defined by IEEEStd 802.3af-2003, and»Power classification 1« (up to 4 W) is supported. The PoE port is not polarity
sensitive.
PIN assignment for PoE
1
Transmit Data +
2
Transmit Data -
3
Receive Data +
6
Receive Data -
45
connected = power supply
78
connected = power supply
Description and installation elmeg IP-S400 at the Ethernet-port
8
8
7
6
5
4
3
2
1
Figure: 6
1
2
3
5
4
6
Figure: 5