Datasheet

PABX functions II
Feature Description
Specified bundle assignment The bundle assignment can be done via the code on standard terminals or via the bundle key
on SysTel.
Call Through (1) Dial 'via system': An incoming call over ISDN or a SIP provider can be used for call through
following authentication with the aid of the PIN and CLIP of an outgoing line (ISDN, SIP
provider and POTS).
Call Through (2) Cheap tariffs, e.g. when dialling abroad, can therefore be used. When the ARS is switched on,
routing is also possible via internal analogue GSM gateways (release option).
Boss/secretary function Functional linking of 2 system telephones - routing of calls via call function
CLIP no screening for point-to-points Sending of call number that does not belong to connector, e.g.: as central call number for call
centre. Application to the provider necessary
CLIPO (Calling Line Identification
Presentation Override)
Transmission of suppressed numbers to special connectors (e.g. police)
Data protection for analogue
extensions
The data protection option prevents call waiting for analogue faxes, modems and door
intercoms.
Date/time Implemented through clock component, clock software, time servers etc. The clock can be
adjusted via FCI, synchronisation with ISDN network time is possible. Automatic changeover
to summer/winter time
Diagnostic function Fault logbook and diagnostic history memory in the system (to be saved to SD card)
Direct call Automatic call setup after x secs to a preset destination after the receiver is lifted without
dialling; can be programmed per user, special dialling tone for active direct calls; adjustable
reaction time of 0 - 39 secs can be adjusted centrally
Three-party conference call Up to 8 three-party conference calls for TDM terminals. Possible procedures during the
conference call: Disconnect individual extensions, return to active connections and
connections on hold
Announcement/announcement block Announcement to system telephone with notification tone for both the calling party and the
called party; can be set per extension
Advanced call assignment for
point-to-points
Additional MSNs (exceptional call numbers) that can be configured centrally for all
point-to-points. For non-configured call numbers, the call is released to a configurable global
default destination.
Fax connection possibility Connection possibility of a fax to analogue or ISDN internal connectors:
Follow me (1) Tracing of call diversion of internal extensions via the code procedure; configuration of follow
me function externally possible by dialling externally in the PABX (service call number) -
protected by PIN2
Follow me (2) The remote switching authorisation is set centrally.
Charges (1) Transmission both during (AOC-D) and at the end (AOC-E) of the call in units or currency
amounts; operation of pay phones at the internal So bus possible
Charges (2) Forwarding of charges to internal analogue/digital connectors, charge pulses 12 kHz/16 kHz,
charge meter per extension
GSM gateway GSM gateways can be switched on on hybird external ISDN ports. The automatic routing via
ARS can be adjusted. The post-dial delay on analogue GSM gateway ports can be configured
centrally, the ISDN clock synchronisation can be switched.
Funkwerk Enterprise Communications GmbH - Suedwestpark 94 - 90449 Nuremberg - Germany
Phone: +49 - (0)911 9673 0
Fax: +49 - (0)911 688 0725
E-Mail: [e-mail] - www.funkwerk-ec.com
hybird
11.03.2011
Subject to technical
alterations