Operation Manual

10
EN
Manual Channel Presetting
You can preset a channel manually and individually.
1) Follow the steps 1) to 3) in the “Automatic Channel
Presetting”.
2) Press Cursor K / L to point to “MANUAL”, then press
ENTER.
3) Press Cursor K / L to point to “POSITION”, then press
ENTER.
4) Press the Number buttons or Cursor K / L to select
your desired position number, then press ENTER.
• You can select position number 01-99.
• If you want to remove scrambled signals, press Cursor K / L
repeatedly to point to “DECODER”. Then, press ENTER.
Press Cursor K / L to select “ON”, then press ENTER.
5) Press Cursor K / L to point to “CHANNEL”, then press
ENTER.
6) Press Cursor K / L to start scanning.
• The tuner will begin to search up or down automatically.
When a channel is found, the unit will stop searching and the
picture will appear on the TV screen.
• You can select desired channel number by using
the Number buttons. You must refer to the following
Channel Plan table and press three digits to select the channel
number.
(To select channel 24, press “0” button first and then press
“2” and “4”.)
• If this is the channel you want, press ENTER.
This unit can receive Hyper and Oscar frequency bands.
7) Press SETUP to exit.
Decoder Allocation
Some TV stations transmit encoded TV signals which can only be
viewed with a purchased or hired decoder. You can connect such
a decoder to SCART1 jack of this unit. The following function
will automatically activate the connected decoder for the desired
TV channel.
1) Press STANDBY-ON to turn on the TV.
2) Press / (prog.) or the Number buttons to select
the TV channel which you would like to allocate the decoder
to.
3) Press SETUP so that the menu display appears on the TV
screen.
4) Press Cursor K / L to point to “CHANNEL TUNING”,
then press ENTER.
5) Press Cursor K / L to point to “MANUAL”, then press
ENTER.
6) Press Cursor K / L to point to “DECODER”, then press
ENTER.
7) Press Cursor K / L to select “ON” (decoder switched on),
then press ENTER.
• To switch off the decoder, press Cursor K / L to select
“OFF”.
8) Press SETUP to exit.
• The decoder has now been allocated to this TV channel.
Channel Plan
TV Channel
CH Indication PAL B/G SECAM D/K
01–10 – –
02–12 E2–E12
13–20 A-H (only ITALY) –
21–69 E21–E69
74–78 X, Y, Z, Z+1, Z+2
80–99, 100 S1–S20, GAP
71–86 – –
90–106 – –
121–141 S21–S41
142–153 – R1–R12
Note:
• To confirm that a channel has been added, press
/ (prog.).
• If you insert the RF cable plug into the ANT. IN jack
after manual channel presetting, the picture will be
distorted. In this case, press / (prog.) to select
the same channel again.
BACK
OK
ENTER
BACK
OK
ENTER
CHANNEL
BACK
AUTO
MANUAL
MOVE
MANUAL CHANNEL
BACK
POSITION
CHANNEL
DECODER
SKIP
P55
055
[OFF ]
[OFF ]
SELECTBACK
SELECTBACK
BACK
OK
ENTER
BACK
OK
ENTER
CHANNEL
BACK
AUTO
MANUAL
MOVE
MANUAL CHANNEL
BACK
POSITION
CHANNEL
DECODER
SKIP
P55
055
[ON ]
[OFF ]
SELECTBACK
SELECTBACK
A73F0EP_EN.book Page 10 Wednesday, September 12, 2007 10:48 AM