User manual

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Pro’ . Press [Setup] to then

select with [Up] | [Down] one of the programmes ‘Pr01’ to ‘Pr12’ .

A preprogrammed automatic show can only be activated when the unit is operating in stand-

alone mode or as master in a master / slave combination. This setting is only relevant if the

device is not controlled via DMX.

If you select ‘Pr01’ , you can press [Setup] and then use [Up] | [Down] to select 15 programmed

colour patterns that are constantly lighting. Or you select ‘-OFF’ to blackout the unit. Press

[Setup] to then select with [Up] | [Down] the strobe frequency from ‘FS01’ (slow) to ‘FS99’ (fast)

or ‘FSFL’ (strobe eect). Select ‘FS00’ for constant light.

Programmes ‘Pr02’ ‑ ‘Pr12’ oer preprogrammed colour sequences. After selecting one of

these programmes, press [Setup] to then select with [Up] | [Down] the speed of the colour

sequences from ‘SP01’ (slow) to ‘SPFL’ (fast). Press [Setup] to then select with [Up] | [Down] the

strobe frequency from ‘FS01’ (slow) to ‘FS99’ (fast).

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘d---’ . Press [Setup] to then

select with [Up] | [Down] the desired DMX address between 1 and 512 (the display shows

‘d001’ … ‘d512’ ). Make sure that this number matches the conguration of your DMX con‐

troller.

This setting is only relevant when the device is controlled via DMX.

Press [Setup] to then select with [Up] | [Down] the DMX mode (2, 4, 6 or 8 channels).

Programme mode

DMX address

Operating

SePar QUAD LED RGB UV IR, SePar QUAD LED RGBW IR

LED PAR