User manual

If you do not press any button for about 15 seconds, the display will turn o. The set values are
retained even when the device is disconnected from the mains power supply.
Press [Mode] repeatedly until the display shows ‘AUTO’ . The unit now operates in automatic
stand-alone mode.
Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [Setup] to then select with [Up] | [Down] the programme speed from ‘SP01’ (slow) to
‘SPFL’ (fast). Press [Setup] to then select with [Up] | [Down] the strobe frequency from ‘FS01’
(slow) to ‘FS99’ (fast). Press [Setup] to then select with [Up] | [Down] the changing frequency
from ‘n001’ (slow) to ‘n100’ (fast).
Auto mode
Operating
SePar QUAD LED RGB UV IR, SePar QUAD LED RGBW IR
29
LED PAR