User manual

1. Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Set’ and conrm with
[Setup].
2. Use [Up] and [Down] to select the menu item ‘Cur’ and conrm with [Setup].
3. With [Up] and [Down] you can select one of the following dimmer curves. The dimmer
curve determines how the brightness increases or decreases depending on the set DMX
value.
Display Meaning
‘Cu-1’ Linear (proportional) course
‘Cu-2’ Non-linear curve with a distinctive at prole at the
beginning and end
‘Cu-3’ Inverted quadratic curve with a steep prole at the
beginning and at prole at the end
‘Cu-4’ Inverted square curve with a steep prole at the
beginning and at prole at the end
The below gure schematically shows the adjustable dimmer curves. Depending on the
selected DMX value (1) the device lights with a brightness (2) between 0% and 100%.
Conrm the selection with ‘Setup’ . Press [Mode].
ð
The selection is applied.
Dimmer curve
Operating
34
SePar Hex LED RGBAW UV IR
LED PAR