User manual

1. The device shows a sound-controlled colour sequence. Press [Setup] to then perform
with [Up] | [Down] the colour setting between ‘S0.01’ and ‘S0.16’ .
2. Press [Setup] to adjust the sensitivity of the built-in microphone for sound control
between ‘SU.00’ (low) and ‘SU.31’ (high).
1. Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘d---’ .
2. Press [Setup] to then select with [Up] | [Down] the desired DMX address between 1 and
512 (the display shows ‘d.001’ ‘d.512’ ). Make sure that this number matches the congu‐
ration of your DMX controller.
This setting is only relevant when the device is controlled via DMX.
3. Press [Setup] to then select with [Up] | [Down] the DMX mode (6, 8 or 10 channels).
Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘SLAv’ .
The device is now working in slave mode, i.e. it will exactly copy the movement of the control‐
ling master device, correct wiring provided.
This setting is only relevant if the device is not controlled via DMX.
Sound control
DMX address
Slave mode
Operating
SePar Hex LED RGBAW UV IR
33
LED PAR