User manual

Press [DOWN]. The display shows ‘Strobe’ . Press [ENTER], then use [UP] and [DOWN] to set a

value between 010 and 255 for the strobe frequency of the show. Values between 000 and 009

have no function here.

When the display shows the desired value press [ENTER] to store the setting. To change the

menu item without making any changes, press [MODE]. Press [MODE] twice to return to the

function selection.

7.3 Settings menu

In this menu you can congure the device according your liking. All previous settings are

retained even when you switch the device o and disconnect it from the mains. Press [MODE]

and conrm with [ENTER] to open the settings menu ‘Set Menu’ .

Press [ENTER] to call up the rst menu item ‘Reload Default’ . With this function, you can reset

the device to its factory default setting. All your previously adjusted settings are thereby irre‐

trievably erased.

If you want to enable this function, use [UP] and [DOWN] to select ‘ON’ and conrm with

[ENTER]. If you want to disable this function, use [UP] and [DOWN] to select ‘OFF’ and conrm

with [ENTER].

Strobe

Resetting to factory defaults

Operating

PicoWash 40Z Pixel Quad

Moving Head