User manual

Press [DOWN]. The display shows ‘Strobe’ . Press [ENTER] to then select with [UP] and [DOWN] a

value between 010 and 255 for the strobe frequency of the show. Values between 000 and 009

have no function here.

When the display shows the desired value press [ENTER] to save the settings. To change the

menu item without making changes, press [MODE]. Press [MODE] twice to return to the func‐

tion selection.

7.3 Settings menu

In this menu you can congure the device according your liking. All previous settings are

retained even when you switch the device o and disconnect it from the mains. Press [MODE]

and conrm with [ENTER] to open the settings menu ‘Set Menu’ .

Press [ENTER] to call up the rst menu item ‘Reload Default’ . With this function, you can reset

the device to factory default setting. All your previously adjusted settings are thereby being

irretrievably erased.

If you want to enable this function use [UP] and [DOWN] to select ‘ON’ and conrm with

[ENTER]. If you want to disable this function use [UP] and [DOWN] to select ‘OFF’ and conrm

with [ENTER].

Strobe

Resetting to factory defaults

Operating

PicoWash 40 Pixel Quad LED

Moving Head