User manual

If necessary, press [DOWN] repeatedly and conrm with [ENTER] to call up the menu item
. Use this function to specify whether you want the display to appear normally or verti‐
cally inverted. This makes reading the display easier when the device is installed upside down.
Use [UP] and [DOWN] to select ‘on’ if the display should appear inverted. Select ‘oFF’ if the
display should not appear inverted. Conrm each time with [ENTER].
If necessary, press [DOWN] repeatedly and conrm with [ENTER] to call up the menu item
. Press [ENTER] again, the display shows . This function allows you to specify
whether the LED lights up in DMX mode during the movements of the device head or not.
Press [ENTER] to call up the function. Use [UP] and [DOWN] to select ‘on’ and press [ENTER] to
enable this function (LED ‘o’ on DMX-controlled movements). Choose ‘oFF’ and press [ENTER]
to disable this function (LED ‘on’ on DMX-controlled movements).
Press [MODE] repeatedly until the display shows again.
Display inverting
Motor Set
Operating
44
PicoSpot 20 LED
Moving Head