User manual

6.1 Remote control
To use the remote control, point its infrared diode at the infrared sensor on the unit and press
the desired buttons. The maximum operating distance is about 9 m. The device will only
respond to the remote control signals if it is not controlled via DMX.
To enable the operation via remote control, press [STAND BY] on the remote control uand then
[FULL ON].
1 [STAND BY] | stops the automatic mode and blackouts the unit. The display shows ‘StoP’ .
In this mode, the device responds to the remote control.
2 [Dimmer + / –] | adjusts the light intensity between 0 and 100 %. Press [Dimmer +]
repeatedly or keep the button pressed to increase the light intensity. Press [Dimmer–]
repeatedly or keep the button pressed to decrease the light intensity.
3 [SOUND OFF] | disables the sound control
4 [SHOW] | To call up one of the four preprogrammed automatic shows, press this button
followed by the number button [1] – [4] for the desired show. To cancel a show, press
[STAND BY].
5 [SOUND ON] | enables the sound control
6 Number buttons | These buttons allow you to trim the rotation (X) and tilt (Y) of the
device head and let you select programmes in show mode:
ö
#
$
%
&
'
(
)
*
+
,
STANDBY
D
IMMER+
D IMMER–
GOBO
COLOR
FULLON
STROBE
SHOW
SOUND ON SOUND OFF
1 2 3
4 5 6
7 8 9
Connections and controls
PicoBlade FX 4x10W RGBW
25
Moving Head