User manual

To use the remote control, point its infrared diode at the infrared sensor on the unit and press
the desired buttons. The maximum operating distance is about 9 m. The device will only
respond to the remote control signals if it is not controlled via DMX.
To enable the operation via remote control, press [STAND BY] on the remote control uand then
[FULL ON].
21 [STAND BY]
Stops the automatic mode and blackouts the unit. The display shows ‘StoP’ . In this
mode, the device responds to the remote control.
22, 23 [Dimmer+] / [Dimmer–]
Adjusts the light intensity between 0 and 100%. Press [Dimmer +] repeatedly or
keep the button pressed to increase the light intensity. Press [Dimmer–] repeatedly
or keep the button pressed to decrease the light intensity.
24 Number buttons
These buttons allow you to trim the rotation (X) and tilt (Y) of the device head:
Infrared remote (optionally
available)
STANDBY
DIMMER+ GOBO
FULL ON
DIMMER–
COLOR
STROBE
1 2 3
4 5 6
7 8 9
SOUND OFF SHOW SOUND ON
6
7
8
?
A
>
=
< ; :
9
Connections and controls
30
PicoBeam 60 COB RGBW
Moving Head