User manual

8 Remote control
To use the remote control, point its infrared diode at the infrared sensor on the unit
and press the desired buttons. The maximum operating distance is about 9 m. The
device will only respond to the remote control signals if it is not controlled via DMX.
To activate remote control operation, press [STAND BY] on the remote control and
then [FULL ON].
The settings you make using the remote control aect all four moving
heads.
1 Infrared diode
Sends the infrared signals to the device.
2 [STAND BY]
Stops the automatic mode and blackouts the unit. The display shows ‘ StoP’ to adapt the values). In this mode, the
device responds to the remote control.
3 [FULL ON]
Press this button to call up the programmed light scene.
4 [GOBO]
No function
5 [Dimmer + / –]
Adjusts the light intensity between 0 and 100 %. Press repeatedly [Dimmer +] or keep the button pressed to increase the
light intensity. Press repeatedly [Dimmer–] or keep the button pressed to decrease the light intensity.
6 [STROBE]
Enables the Strobe function for the current light scene. Then press one of the number buttons [2] - [9] for the desired
strobe frequency. Press the number button [1] to disable the strobe function.
7 [COLOR]
To call up various colours for the current light scene. Then press one of the number buttons [1] - [8] for the desired
colour.
8 Number buttons
These buttons allow you to trim the rotation (X) and tilt (Y) of the device head:
[1]: X– & Y+
[2]: Y+
[3]: X+ & Y+
[4]: X–
[5]: Centre
[6]: X+
[7]: X– & Y–
[8]: Y–
[9]: X+ & Y–
STAND BY
FULL ON GOBO DIMMER
+
STROBE COLOR
DIMMER
–
SOUND ON SHOW SOUND OFF
7 8 9
4 5 7
1 2 3
#
)
,
&$
ö
%
'
(
*
+
Remote control
Mr. Beam 120 W
27