User manual
Table Of Contents
1. Press [UP] or [DOWN] until the display shows ‘ModE’ .
2. Press [ENTER] and select with [UP] and [DOWN] the desired stand-alone mode (Soun,
AUto).
3. Conrm your selection with [ENTER].
1. Press [UP] or [DOWN] until the display shows ‘ModE’ .
2. Press [ENTER] and use [UP] or [DOWN] to select the mode ‘SLAV’ .
3. Conrm your selection with [ENTER].
4. Connect the slave devices and the master device (same model) to each other with a
DMX cable. Start with the DMX output of the device, which is congured as master
device.
5. On the master device, activate the desired standalone mode auto control ‘AUto’ or
sound control ‘Soun’ .
ð
The slave devices now follow the settings of the master device.
Setting the standalone mode
Setting the slave mode
Operating
LED eect
26