User manual

This setting is only relevant when the device is controlled via DMX.
Press [Mode] until the display shows ‘d.xxx’ . Press [Setup].
Now you can set the number of the rst DMX channel to be used by the device (DMX address).
Use [Up] and [Down] to select a value between 1 and 512 (display shows ‘d.001’ … ‘d.512’ ).
Make sure that this number matches the conguration of your DMX controller. The following
table shows the highest possible DMX address for the various DMX modes.
Mode Highest possible DMX address
4-channel 509
6-channel 507
8-channel 505
16-channel 497
Press [Setup]. With [Up] and [Down] you can select one of the following DMX operating modes:
n ‘4-CH’ (four channels)
n ‘6-CH’
(six channels)
n ‘8-CH’ (eight channels)
n ‘16CH’
(sixteen channels)
DMX mode
Operating
28
LED Pot System COB 40W RGB WW
LED Lighting Set