User manual

A constant unicoloured pattern can only be activated when the unit is operating in stand

alone mode or as master in a master / slave combination. This setting is only relevant if the

device is not controlled via DMX.

Press [Mode] repeatedly until the display shows ‘CoLr’ . Press [Setup].

Now use [Up] and [Down] to select one of the following options:

Display Meaning

‘r.000’ … ‘r.255’ Red

‘g.000’ … ‘g.255’ Green

‘b.000’ … ‘b.255’ Blue

‘u.000’ … ‘u.255’ White

To adjust the ash frequency, press [Setup] repeatedly until the display shows ‘FS.xx’ . Now use

[Up] and [Down] to select a value between ‘FS.00’ (slow) and ‘FS.99’ (fast).

Constant unicoloured pattern

Operating

LED lighting set