User manual

n ‘16CH’ (sixteen channels)

A sound-controlled show can only be activated when the unit is operating in stand alone

mode or as master in a master / slave combination. This setting is only relevant if the device is

not controlled via DMX.

Press [Mode] repeatedly until the display shows ‘Soud’ . Press [Setup]. Use [Up] and [Down] to

activate one of the available sound modes ‘SO.00’ … ‘SO.38’ .

Press [Setup]. Now you can adjust the sensitivity for the sound control. Use [Up] and [Down] to

select a value between 0 (low sensitivity) and 31 (high sensitivity), display shows ‘SU.00’ …

‘SU.31’ . The selected sensitivity also applies to the sound control activated via DMX.

The light eect keeps running slowly if no sound signal is received.

Sound control

Operating

LED Pot SystemCOB 40W RGB WW