User manual

A preprogrammed automatic show can only be activated when the unit is operating in stand-
alone mode or as master in a master / slave combination. This setting is only relevant if the
device is not controlled via DMX.
Press [Mode] repeatedly until the display shows ‘Pro’ . Press [Setup]. Now you can select one of
the preprogrammed automatic shows. Use [Up] and [Down] to select a value between ‘Pr.01’
and ‘Pr.38’ .
Settings for programme 01:
For ‘Pr.01’ , you can choose from 16 basic colours, maximum intensity or blackout of all LEDs.
Press [Setup]. Now use [Up] and [Down] to select one of the following options: Blackout, Red,
Green, Blue, White, Amber, Orange, Yellow, Magenta, Pink, Cyan, Light red, Light green, Light
blue, Warm white, Cold white.
To adjust the ash frequency, press [Setup]. Use [Up] and [Down] to select a value between
‘FS00’ (slow) and ‘FS99’ (fast).
Settings for programmes 02 … 28:
To adjust the speed of the selected auto show, press [Setup] repeatedly until the display indi‐
cates ‘SPxx’ . Now use [Up] and [Down] to select a value between ‘SP.01’ (slow) and ‘SP.99’
(fast) or ‘SP.FL’ .
To adjust the ash frequency, press [Setup] repeatedly until the display shows ‘FS.xx’ . Now use
[Up] and [Down] to select a value between ‘FS.00’ (slow) and ‘FS.99’ (fast).
Operating mode ‘Preprog‐
rammed automatic show’
Operating
LED lighting set
34