User manual

6.5 Operating mode ‘Sound’

This setting is only relevant if the device is working as Slave in a Master / Slave conguration

and is not controlled via DMX. In this operating mode, the device responds to acoustic pulses

which are recorded by the integrated microphone.

1. Press [Mode] repeatedly until the display shows ‘Soud’ .

2. Use [Up] and [Down] to set the sensitivity of the built-in microphone in a range from

‘SU.00’ … ‘SU.31’ .

6.6 Reset to factory defaults

In this menu, you can reset the device to factory default settings.

1. Press [Mode] repeatedly until the display shows ‘-rst’ .

2. Conrm with [Setup].

Alternatively, you can reset the device to factory defaults during switching on. Switch the

device o and on again holding the buttons [Mode ] and [Setup] pressed for about 2 seconds.

Operating

LED Pot Strobe 100

Stroboscope