User manual

7.6 Sound control

Sound control can only be activated when the unit is operating in stand alone mode or as

master in a master / slave combination. This setting is only relevant if the device is not con‐

trolled via DMX. In this operating mode, the device responds to acoustic pulses which are

recorded by the integrated microphone.

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Soud’ . Press [Setup] and use

[Up] | [Down] to adjust the microphone sensitivity in a range of ‘SU.00’ … ‘SU.31’ .

7.7 Reset to factory defaults

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Set’ . Press [Setup], the display

shows ‘-rSt’ . Press again [Setup] to reset the device to the factory default settings. Use [Up] |

[Down] to select either ‘-YES’ to conrm the reset to factory settings, or ‘--NO’ , to cancel the

reset to factory settings.

Operating

LED Pot COB 40W RGB WW