User manual

7 Operating

Connect the device to the power supply to start operation. After a few seconds the unit is

ready for use.

Press [Mode] or [Up] | [Down] to open the main menu and select a menu option. Open the indi‐

vidual menus with [Setup] and change the respectively displayed value with [Up] | [Down].

Changed values and settings will immediately take eect. With [Mode] , you return to the pre‐

vious menu level.

7.1 Operating mode Auto

Automatic operation can only be activated when the unit is operating in stand alone mode or

as master in a master / slave combination. This setting is only relevant if the device is not con‐

trolled via DMX.

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘AUTO’ . Conrm with [Setup].

The device now works in automatic stand-alone mode, the programmes ‘Pr.02’ … ‘Pr.14’ run

sequentially at the set programme and strobe speed.

Operating

LED Pot COB 40W RGB WW