User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
7.4 Operating mode Slave
This setting is only relevant if the device is not controlled via DMX.
Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘SLAv’ . The device now oper‐
ates in slave mode and follows the sequences of the controlling master device.
7.5 Operating mode Dimmer
Dimmer operation can only be activated when the unit is operating in stand alone mode or as
master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Colr’
. All LEDs light with the
set intensity. Press [Setup] and adjust the intensity of the four basic colours in turn as desired:
n Red: ‘r.000’ … ‘r.255’
n Green: ‘g.000’ … ‘g.255’
n Blue: ‘b.000’ … ‘b.255’
n White: ‘u.000’ … ‘u.255’
Operating
34
LED Pot COB 40W RGB WW
LED PAR