User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
7 Operating
Connect the device to the power supply to start operation. After a few seconds the unit is
ready for use.
Press [Mode] or [Up] | [Down] to activate the main menu and select a menu option. Open the
individual menus with [Setup] and change each displayed value with [Up] | [Down]. Changed
values and settings will immediately take eect. Press [Mode] to return to the previous menu.
7.1 Operating mode Auto
Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘AUTO’
. Conrm with [Setup].
The device now works in automatic stand-alone mode, the programmes ‘Pr.02’ … ‘Pr.14’ run
sequentially at the set programme and strobe speed.
Operating
LED Pot COB 40W RGB WW
25
LED PAR