User manual

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Soud’ . Conrm the selection

with [Setup]. Use [Up] | [Down] to select a mode between ‘SO.01’ … ‘SO.12’ . Conrm the selec‐

tion with [Setup]. Use [Up] | [Down] to adjust the microphone sensitivity in a range from

‘SU.00’ … ‘SU.31’ .

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘SEt’ . Press [Setup], the display

shows ‘-rSt’ . If you press [Setup] again during the display, the device is being reset to factory

defaults. All your previously adjusted settings are thereby being irretrievably erased. Press

‘MODE’ to cancel the procedure.

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘InFo’ . Press [Setup], the dis‐

play shows ‘tEnP’ . Press [Setup] again. The display shows ‘t-on’ . If you press [Up] or [Down]

while the display shows ‘tEnP’ , the display shows ‘VEr’ . Press [Setup] to let the device show the

rmware version.

Sound mode

Resetting the device

Information display

Operating

LED PAR