User manual

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘d---’ . Press [Setup] to then

select with [Up] | [Down] the desired DMX address between 1 and 512 (the display shows

‘d.001’ … ‘d.512’ ). Make sure that this number matches the conguration of your DMX con‐

troller.

Press [Setup] to then select with [Up] | [Down] the number of channels (4, 6 or 8) available for

DMX operation.

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘SLAv’ . The device is now

working in slave mode, i.e. it will exactly copy the movement of the controlling master device,

correct wiring provided.

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Colr’ . All LEDs light with full

intensity. Press [Setup] to then select with [Up] | [Down] the intensity of the red LEDs between

‘r.000’ (o) and ‘r.255’ (full). Press [Setup] to then select with [Up] | [Down] the intensity of the

green LEDs between ‘g.000’ (o) and ‘g.255’ (full). Press [Setup] to then select with [Up] |

[Down] the intensity of the blue LEDs between ‘b.000’ (o) and ‘b.255’ (full). Press [Setup] to

then select with [Up] | [Down] the intensity of the white LEDs between ‘u.000’ (o) and ‘u.255’

(full).

DMX address

Slave mode

Colour mode

Operating

LED Pot 12×1W RGBW, LED Pot 12×1W WH RGBW