User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Colour Display
Light blue ‘13’
Warm white ‘14’
Cold white ‘15’
When you have selected one of programmes 02 … 14 you can adjust the following settings:
1. After selecting the programme, press [Setup] again and set the programme sequence
speed with [Up] | [Down] in the range from ‘001’ … ‘100’ (slow … fast).
2. Press [Setup] again and set the ashing speed for the strobe function with [Up] | [Down]
in the range from ‘001’ … ‘100’ (slow … fast).
7.3 Operating mode DMX
This setting is only relevant if the device is controlled via a DMX controller.
1. Use [Mode] or [Up] | [Down] to select the menu option ‘d—’ and conrm this with
[Setup].
2. Use [Up] | [Down] to assign a DMX address in a range from ‘d.001’ … ‘d.512’ to the
device and conrm with [Setup].
Settings for programmes
02 … 14
Operating
28
LED Pot 12×1W QCL RGB WW 15°, LED Pot 12×1W QCL RGB WW 40°
LED PAR