User manual
Table Of Contents
6 Operating
6.1 Switching the device on / o
Perform the following steps to switch the device on:
1. Verify that all required laser safety precautions have been taken. Make sure that there is
no one in the reach of the laser beam.
2. Connect an external safety switch to the [REMOTE] connection (e.g. an emergency stop
button) or another equivalent device with protection function.
3. Insert the safety key into the lock.
4. If not already done, connect the device to the mains. After a few seconds, the fan and
the motors start to work. The display shows the current operation mode. The device is
now operational.
5. Turn the safety key to the ‘ON’ position to turn the laser beam on.
Switching on
Operating
LED eect
30