User manual

6 Operating
Connect the supplied USB-C power supply to the mains grid to start operation. After a few sec‐
onds the unit is ready for use.
Slide the mode selector on the rear of the device to [AUTO] to enable the Auto mode. The pre‐
programmed automatic programmes are played automatically.
Slide the mode selector on the rear of the device to [SOUND] to enable the sound control.
Slide the mode selector on the rear of the device to [CLOSE] to enable the infrared sensor. The
device is now controlled exclusively via the supplied infrared remote control.
Automatic mode
Sound control
Enabling
Infrared remote control
Operating
Colour Burst MKll
17
LED Flower Eect