User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
7 Operating
Turn on the power using the main switch. After a few seconds the unit is ready for use.
1. Press [Mode] or [Up] | [Down] to activate the main menu and select a menu option.
2. Conrm the selection with [Setup].
3. Change the currently displayed value with [ Up] | [Down]. Changed values and settings
will immediately take eect. Press [Mode] to return to the previous menu.
7.1 Operating mode Auto
Automatic operation can only be activated when the unit is operating in stand alone mode or
as master in a master / slave combination. This setting is only relevant if the device is not con‐
trolled via DMX.
1. Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘AUTO’ .
2. Conrm the selection with [Setup].
ð
The device now operates in automatic stand-alone mode, the programmes
‘Pr.02’ … ‘Pr.14’ run sequentially at the set programme speed.
Operating
28
LED Pot QCL RGB WW 15°, LED Pot QCL RGB WW 40°
LED PAR